Big systems, on a positioned base and calibrated washing, on the edge of the transfers for big and complex elements such as gear boxes, skids, etc..

Robojet

Innovative and patented system designed to carry out washing operations of complex parts with hard-to-reach surfaces.

This new calibrated and positioned washing system allows you to work with different sequences of pieces by simply choosing the corresponding program.

By using one of the most advanced patented washing systems on the market today, you can program the movement of the washing nozzles in relationship to the movement of the pieces so they are sure to reach the most difficult areas to clean (blind holes, internal chambers, fluid circulation ducts, etc.) according to a programmable procedure developed to guarantee that the cleaning parameters required are met. The liquids used are hot water and biodegradable detergent solutions, all extensively tested so as to assure the best results.

Computerized Logical Programming (Plc) runs all system functions and especially controls the following processes:

• Jet spray movement
• Piece movement
• The use of only those jets which are strictly necessary

The Plc can handle different washing programs.

This system operates on pre-set modes and sequences with respect to shapes that have been memorised by the computer. It can be set to either completely wash the loaded parts or just certain areas of them, which assures particularly precise and efficient cleaning.

This allows considerable savings in terms of time, labour, energy and detergents, with a considerable reduction in the amount of waste liquid to be drained and in the separate recovery of contaminants (chips, oil, grease, etc.). This system is made up of a washing chamber with a separate tank and a high pressure vertical pump. The loading base, installed on a mobile trolley, is equipped with calibrated housings which hold the pieces and allow for easy handling.

In summary, the operational phases are the following:

• Loading of the piece on the appropriate calibrated housing
• The following washing cycle is started by pushing a button
• Loading the piece into the washing chamber
• Closing the washing chamber door
• Starting the washing, blowing and drying cycles on the basis of the types of pieces to be washed
• Steam aspiration (and condensation if required)
• Opening of the washing chamber door
• Moving of the piece back to the starting point
• The operator can now take the piece out and put a new one in
• This process, exclusively developed by Teknox, obtains results which satisfy the UNI 4406 quality standards.
• Automatic: door closing, carrying out of the cycle, basket centring and door opening
• 30% energy saving with HT models